Once in place, remove the other backer from the tape.ĥ) Starting at the carriage side, slide the cutting strip under the carriage and then move the carriage out of the way so you can position the cutting strip correctly.Ħ) Press down firmly across the entire length of the cutting strip. It is important that the channel be clear so that the new strip will be at the same level across its full lengthĤ) Cut double-sided tape to the required length, peel one of backers and place tape in the cutting channel. SuperTape is ultra clear and heat resistant, perfect for heat embossing on cards and as custom accents.ġ) Move the carriage to one side of the cutterĢ) With a knife or flathead screwdriver, pry up and remove the old cutting stripģ) Clear old glue/tape from the cutting channel with the flathead screwdriver.Īny excess glue/tape can be cleaned with Alcohol, Acetone, or Toluene.

Simply decorate the tape itself to use as a custom embellishment. However the iCraft SuperTape can also adhere metals, paper, rubber charms, ribbon, wood, beads, seed beads, micro beads, glitter, sand, shells, heavy or bulky items. We here at USCutter recommend using to hold down replacement cutting strips. ICraft SuperTape is the strongest acid-free clear adhesive available. ICraft SuperTape for Replacement Cutting Strips If using double-sided tape, you may purchase from us or source this common tape yourself. Whichever technique you choose, the important thing is to make sure that the cutting strip is at the same level all the way across so that blade pressure is constant when cutting. Note that although E6000 glue remains flexible and generally pulls up in one piece, it may take more effort to remove glue when changing strips the next time. If your environment has increased heat or cold or humidity, you may want to use E6000 glue, which is not impacted by temperature changes. If your cutter is likely to be used in a temperature controlled environment, double-sided tape should be sufficient. Depending on the environmental conditions where you will use your cutter, you may want to use either double-sided tape or adhesive glue. NOTE: This cutting strip does NOT come with an adhesive, however, we offer two adhesive options for you to choose from in the pull-down option menu.Ĭutting strips are designed to be non-stick, so special care must be taken to use an appropriate adhesive to keep them in place. Gouges or adhesive residue on the strip can accumulate over time and usage and cause tracking errors on your cut job.

Replace your cutting strip every 6 months to a year depending on your usage. USCutter Replacement Cutting Strip for MH Series Vinyl Cutters Solvent and Eco-Solvent Compatible Media.

Mh 721 cutter